رد: بخصوص Pinout repair boot jtag
مشكور اخي مشي الحال تمام
تم تلحمية وقراء في البوكس
الجهاز اخد سوفت خطاء تبع s5360
عملت ايريس فلاش في الاول
وهذا لوج العملية
Open serial port...OK
Connecting to the RIFF Box...OK
Firmware Version: 1.37, JTAG Manager Version: 1.56
Selected Resurrector: [Samsung S5830i V1.0.4476.13359]
Connecting to the dead body...OK
Detected dead body ID: 0x07B3617F - CORRECT!
Set I/O Voltage reads as 3.01V, TCK Frequency is RTCK
Adaptive Clocking RTCK Sampling is: [Sample at MAX]
Settings Code: 0x04010000000000000000000000000000
Resurrection sequence started.
Establish communication with the phone...OK
Initializing internal hardware configuration...OK
Uploading resurrector data into memory...OK
Starting communication with resurrector...OK
Detected an Initialized FLASH1 Chip, ID: 0x00EC/0x0050 (512MB)
Erasing FLASH1 memory from 0x000000000000 to 0x00001FFFFFFF...OK
WARNING: Erasing Error (0x24) at 0x00000C700000. Attempt to Repeat again.
WARNING: Erasing Error (0x24) at 0x00000C700000. Attempt to Repeat again.
WARNING: Erasing Error (0x24) at 0x00000C700000. Attempt to Repeat again.
WARNING: Erasing Error (0x24) at 0x00000C700000. Attempt to Repeat again.
WARNING: Erasing Error (0x24) at 0x00000C700000 is Ignored. Erase continues.
Completed in 00:00:51.641 (Average Transfer Rate: 10152.55 kB/s)
ورجعت البوت تمام
وفلشت فلاش دامب
Adaptive Clocking RTCK Sampling is: [Sample at MAX]
Settings Code: 0x25010000000000000000000020000000
Resurrection sequence started.
Establish communication with the phone...OK
Initializing internal hardware configuration...OK
Uploading resurrector data into memory...OK
Starting communication with resurrector...OK
Detected an Initialized FLASH1 Chip, ID: 0x00EC/0x0050 (512MB)
Writting FLASH1 memory from 0x000000000000 to 0x00001FFFFFFF
WARNING: Programming Error (0x24) at 0x00000C700000 is Ignored.
Completed in 00:49:06.829 (Average Transfer Rate: 183.48 kB/s)